Toshiba Magnia 3200 User Manual
Page 14
Fault report function
If a fault occurs in the Agent machine, fault information can be reported to the
Management Console. There are two ways to send a report to the Management
Console:
1. Displaying an Alert Message on the Management Console
2. Sending an e-mail to a designated component (Management Console or other)
Five fault levels are specified: Information, Warning, Error, Success Audit, and Failure
Audit.
Events written to the event log on the Agent machine are reported to the Management
Proxy. These events reported by the Agent function can be filtered.
(3.3.10 Configure Alerts screen)
Information on faults at the Agent machine that were reported to the Management Proxy
can be filtered and forwarded to the Management Console or to an e-mail destination.
(3.4.4 Alert Message Location screen)
Front panel indicator function
It enables the user to type a specified character string via the Management Console to
change the information displayed on the front panel display of the Agent machine.
This function is supported on following machines: MAGNIA Z300/Z310
Performance display function
This is the function to display the performance of the Agent machine. If threshold values
are set, events will be written to the event log on the Agent machine when a value
exceeds the specified threshold.
Mobile IP Software function
This is the function to display information about the Mobile IP Software Server. (It is an
optional product.) Please refer to the User's Guide of the Mobile IP Software.
The versions of the Mobile IP Software Server that the HEW supports are Ver.2.0, 2.1 and
2.2.
This function is supported on following machines: MAGNIA Z300/Z310/Z500
(3.3.6 Mobile IP Software screen)
Software Access Point function
This is the function to display information about Software Access Point.
Please refer to User's Guide of the Software Access Point.
The version of the Software Access Point that the HEW supports is Ver.2.0.
This function is supported on following machines: MAGNIA Z300/Z310/Z500
(3.3.7 Software Access Point screen)
4