Toshiba Magnia 3200 - Manual (Page 29)

3-2. Installing the Agent
Select the component “Agent“ and the components you need to install. The supported
components for each model are as follows.
MAGNIA
Z300/Z310
MAGNIA
Z500
MAGNIA
3200
MAGNIA
3300
MAGNIA
3310
Sensor Status OK (*1) OK (*1) OK OK (*1) OK (*1)
S.E.L OK (*1) OK (*1) OK OK (*1) OK (*1)
Automatic Server
Restart
OK OK OK OK OK
Remote Power
Control
OK (*2) OK (*2) NG OK (*6) OK
Performance OK OK OK OK OK
Configure Alerts OK OK OK OK OK
ASD OK OK NG NG NG
Panel Control OK NG NG NG NG
Collect Logs OK OK OK OK OK
Mobile IP Software OK (*3) OK (*3) NG NG NG
Software Access Point OK (*4) OK (*4) NG NG NG
HDD Connector Board
Log
NG OK (*5) NG NG NG
LAN Alerting NG NG NG NG OK
MAGNIA
550D
MAGNIA
560S
Sensor Status OK (*8) OK
S.E.L NG NG
Automatic Server
Restart
NG OK
Remote Power
Control
NG NG
Performance OK OK
Configure Alerts OK OK
ASD NG NG
Panel Control NG NG
Collect Logs OK OK
Mobile IP Software NG NG
Software Access Point NG NG
HDD Connector Board
Log
NG NG
LAN Alerting NG NG
OK: Installable NG: Not installable
(*1) When you use this function while the operating system is inactive, the Remote Power
Control function is necessary. (When you use this function in a MAGNIA3300 while the
operating system is inactive, the BIOS needs to be V2.0 or higher.)
(*2) The ASD function is necessary.
(*3) This component can be installed when the Mobile IP Software Server is installed.
(*4) This component can be installed when the Software Access Point is installed.
(*5) When an IDE HDD is not connected to the server, or when the server is equipped with an
IO device chassis, this function is not necessary. So, please remove the check mark of
the check box.
19