BT On-Air DECTf@x Plus F@x machine and digital telephone system - Manual (Page 30)

Using your handset
29
4 To end the call, press the red button.
You can dial the number before pressing the
green button:
1 Dial the number you want to call.
Use the
C button to delete numbers to make
sure you don’t dial a wrong number.
2 Press the green button. The number entered
is dialled after a few seconds.
To receive a call
1 When your handset rings press the green
button.
2 Press the red button to hang up after the call
is over.
Answering mode
You can set the handset to automatically
answer and finish calls when you remove and
replace the handset in the charger. There are 3
settings: -
Mode
0: the feature is off and you must always
press the green button to answer a call and the
red button to end a call.
Mode 1: lift the handset from the charger whilst
it is ringing and it will automatically answer the
call.
Replacing the handset in the charger will end
the call.
Mode
2: you must always press the
green
button to answer a call but replacing the
handset in the charger will end the call.
To choose the mode
1 Press OK . The display shows
F (function).
Then press 8 . The display shows F8 and the
current mode setting (
0 , 1 or 2).
2 Use the ▲ or the ▼ button to change the
mode.
If you hear beeping from the handset while you are
using it, it means that the battery is running low
and needs charging.
If you hear fax tones when you answer the handset
pressing # then 7 will automatically transfer the
signal to the fax machine.
NOTE
If the handset is not in the charger then you must
always press the green button to answer a call and
the red button to end a call.