Bell 36028 - Manual (Page 11)

2. Listen for a dial tone.
3. Dial the telephone number. The phone numbers appear on the LCD Display as you
enter the number.
4. When finished with your call, press the TALK button or place the handset on the
base unit.
NOTE: The call timer will start to count once you press the TALK button.
Receive a Call
NOTE: If you are expecting incoming calls, the handset must be programmed to RING
ON mode.
If the handset is on the base:
1. When the phone rings, simply pick up the handset from the base cradle if the unit is set to
auto-answer ON mode. If the unit is set to auto-answer OFF mode, press the TALK button. See the
"AUTO ANSWER ON/OFF" section to set auto-answer mode. The LCD Display will show
"TALK".
2. Start your conversation.
3. To end your conversation, either press the TALK button or place the handset on the base unit.
If the handset is out of the base:
1. When the phone rings, press the TALK button on the handset. The LCD Display will show " TALK"
and the base unit IN USE LED will light up.
2. Start your conversation.
3. To end your conversation, either press the TALK button or place the handset on the base unit.
Last Number Redial
A. AFTER HEARING A BUSY TONE WHEN PLACING A CALL
1. If you get a busy tone, press handset TALK button to hang up.
2. Press the handset TALK button again and listen for a dial tone.
3. Press the handset RE/PA/DEL button. This will automatically redial the last telephone number you
called (up to 32 digits).
4. When finished with your call, press the TALK button or place the handset on the base unit.
B. WHEN THE HANDSET IS OFF THE BASE UNIT AND IN STANDBY MODE
1. Press the TALK button on the handset and listen for a dial tone.
2. Press the RE/PA/DEL button. This will automatically redial the last telephone number you called
(up to 32 digits).
3. When finished with your call, press the TALK button or place the handset on the base unit.
SAVING IN THE PHONEBOOK
1. Press the SAVE/PHONE BOOK button.
2. Press the EDIT/FLASH button.
3. Use the TELEPHONE KEYPAD button(0-9) to enter the name, (see the "TELEPHONE KEYPAD
CHARACTERS SETTING" section ) you can store up to 15 characters.
4. Press the DN button once.
5. Enter the telephone number using the TELEPHONE KEYPAD button(0-9). You can store up to 16
digits.
6. Press the SAVE/PHONE BOOK button to save into memory
7. Press the SA/PHONE BOOK button to go back to standby mode.
NOTE: If there are no memory locations left in the phonebook, the unit will display
" MEMORY FULL". To continue with memory programming, you must delete
or edit existing speed dial numbers. If no active buttons are pressed for 20 seconds, the LCD
Display will automatically return to STANDBY mode. It will not save a duplicate telephone
030206A-1 10