Bell 36028 - Manual (Page 23)

030206A-1 22
You will hear the newly programmed 3-digit security code.
NOTE: The factory preset password is " 159".
OUTGOING MESSAGE (OGM)
This is the announcement callers will hear when 36028 answers a call. The 36028 also has a default OGM
(factory preset) which is active when there is no OGM present.
Default OGM: "Please record your message after the beep."
RECORDING THE OUTGOING MESSAGE (OGM) (The maximum recording time is 59 seconds.
The minimum recording time is 3 seconds)
1. In standby mode, Press the OGM button.
2. Press and hold the OGM button.
3. Record your greeting after you hear a beep tone.
4. Press the OGM button after you finish recording your greeting. Your recorded greeting will be
played.
CHECKING THE OUTGOING MESSAGE (OGM)
1. In standby mode, press the OGM button on the base unit to hear your previously recorded OGM.
2. You can stop OGM playback anytime during playback by pressing the PLAY/STOP button.
RECORDING A MEMO
Memo message(s) is recorded on the base unit. The maximum recording time is 1 minutes. The minimum
recording time is 3 seconds.
1. In standby mode, Press the MEMO button.
2. Press and hold the MEMO button.
3. Record your greeting after you hear a beep tone.
4. Press the PLAY/STOP button after you finish recording your greeting.
ERASING MESSAGES
A. SELECTIVE ERASING
1. Press the ERASE button on the base unit during message playback.
2. And then start the next message.
B. ERASING ALL ICM AND MEMO
1. In standby mode, press and hold the FRASF. button for about 2 seconds.