Philips Azur Fer vapeur User Manual
Page 20
Problem
Possible cause
Solution
The iron
does not
produce any
steam.
There is not
enough water in
the water tank.
Fill the water tank (see chapter
‘Preparing for use’, section ‘Filling
the water tank’).
The steam control
is set to position 0.
Set the steam control to a
position between 1 and 6 (see
chapter ‘Using the appliance’,
section ‘Steam ironing’).
The iron is not hot
enough and/or the
drip-stop function
has been activated.
Set an ironing temperature that
is suitable for steam ironing ( 2
to MAX). Put the iron on its heel
and wait until the temperature
light has gone out before you
start ironing.
The iron
does not
produce a
steam boost.
You have used
the steam boost
function too often
within a very short
period.
Continue ironing in horizontal
position and wait a while before
you use the steam boost function
again.
The iron is not hot
enough.
Set an ironing temperature at
which the steam boost function
can be used ( 3 to MAX). Put
the iron on its heel and wait until
the temperature light has gone
out before you use the steam
boost function.
Water
droplets drip
onto the
fabric during
ironing.
You have not closed
the cap of the filling
opening properly.
Press the cap until you hear a
click.
EnGlish
20