Britax ROUND ABOUT 50 - Manual (Page 20)

18
Installation: Rear-Facing
Lap-Shoulder Belt Installation
• Figure A illustrates a typical rear-facing, lap-
shoulder belt installation.
• When not in use, always store the LATCH
connectors in the storage slots.
See page 34.
• See vehicle owner’s manual to determine what
type of seat belt system your vehicle has, and
how to lock it (also see pg 10-13).
IMPORTANT: This child seat is shipped with the
buckle in position 1 (Fig. B). Use buckle position
1 or 2 that is closest to but not underneath your
child. Do not use buckle position 3 in rear-facing
mode. See page 38 for Adjusting Harness Buckle
Position.
A
1 Recline the child seat then place it rear-facing
on the vehicle seat. This child seat must be in
the recline position when installed rear-facing.
See Recline Adjustment on page 34.
2 Pull the vehicle belt out then pass it through
the first rear-facing belt slot (Fig. C).
3 Route the vehicle belt across the child
seat and then through the second rear-
facing belt slot.
IMPORTANT:
• The vehicle belt must rest IN FRONT OF the
child seat buckle when using buckle slots 1
or 2 (Fig. B).
• Vehicle belt can be routed over or under the
cover.
4 Verify that the vehicle belt is not twisted and
then buckle (Fig. D).
5 Push the child seat firmly into the vehicle seat
while removing slack first from the lap portion
of the vehicle belt, then the shoulder portion
(Fig. E).
D
b
C