Britax ROUND ABOUT 50 - Manual (Page 42)

40
Securing Your Child
7 Gently pull up on the harness straps to tighten
the lap section of the harness, which should fit
low on the child’s body.
8 Slowly pull the adjuster strap to tighten the
harness around the child (Fig. E).
NOTE: Pull the harness adjuster strap away from the
child seat (parallel to the ground) to tighten. Do not
pull at a sideways angle (see diagrams below).
9 Position the chest clip at the middle of the child’s chest, level with the
armpits (Fig. F).
10 Verify that harness is not twisted and child is properly secured.
IMPORTANT:
• Always pull on the harness after securing the child to ensure the buckle
tongues are secure in the harness buckle. If the buckle will not fasten with
an audible click after inserting each buckle tongue, the harness buckle or
adjuster area may be clogged with food, drink or other debris that must
be removed. See page 43 for cleaning instructions.
• Adjust the belts provided with this child seat so they fit snugly around your
child. A snug strap should not allow any slack. It lies in a relatively straight
line without sagging. It does not press on the child’s flesh or push the
child’s body into an unnatural position.
F
E