Britax ROUND ABOUT 50 - Manual (Page 35)

33
Child Seat Functions
Switching the LATCH Mode
The LATCH connector strap must be switched to
the correct belt path for rear-facing (Fig. D) versus
forward-facing (Fig. E) installation modes.
Complete the following procedure to switch the
LATCH mode.
1 Lift the front of the child seat cover to access
the LATCH connectors.
2 Pull the LATCH strap and connectors from the
child’s right side of the child seat.
3 Thread the LATCH strap and connectors
through the appropriate belt path for the
installation procedure you wish to use.
IMPORTANT: When installing this child seat in rear-
facing mode, the LATCH strap must rest IN FRONT
OF the child seat buckle when using buckle slots 1
or 2 (Fig. F).
NOTE: To ensure LATCH connector is properly
aligned with the vehicle LATCH anchor, the red
release button on the connector should face away
from the vehicle seat back, and the larger of the two
connector sections is on top (Fig. G).
4 Replace the cover and continue with LATCH
installation procedure.
D
E
G
Top
Release
Button
F