Britax ROUND ABOUT 50 - Manual (Page 22)

20
Installation: Rear-Facing
1 Recline the child seat and then place it rear-
facing on vehicle seat. This child seat must be
in the recline position when installed rear-facing.
See Recline Adjustment on page 34.
2 Pull the vehicle belt out and pass it through
the closest rear-facing belt slot (Fig. C).
3 Route the vehicle belt across the child seat
then through the second rear-facing belt
slot.
IMPORTANT:
• The vehicle belt must rest IN FRONT OF the
child seat buckle when using buckle slots 1 or
2 (Fig. B).
• Vehicle belt can be routed over or under the cover.
Lap-Belt Installation
• Figure A illustrates a typical rear-facing, lap-belt
installation.
• When not in use, always store the LATCH
connectors in storage slots. See page 34.
• See vehicle owner’s manual to determine what
type of retractor your vehicle has and how to
lock it (also see pg 10-13).
IMPORTANT: This child seat is shipped with the
buckle in position 1 (Fig. B). Use buckle position
1 or 2 that is closest to but not underneath your
child. Do not use buckle position 3 in rear-facing
mode. See page 38 for Adjusting Harness Buckle
Position.
A
b
C