Britax ROUND ABOUT 50 - Manual (Page 24)

22
IMPORTANT: This child seat is shipped with the buckle
in position 1 (Fig. B). Use buckle position 1, 2 or 3 that is
closest to but not underneath your child. See page 38 for
Adjusting Harness Buckle Position.
1 If stored, remove the LATCH connectors from
the storage slots under the cover (page 34) and
pull both connectors competely through the
child seat’s right side (Fig. C).
2 Press and hold the LATCH adjuster release
button, then pull the LATCH strap to full length.
3 Thread one LATCH connector through the
forward-facing belt path to the opposite side of
the child seat. Ensure that the LATCH strap is
not twisted.
4 Remove the Versa-Tether from the pouch and
place it up and over the child seat back.
5 Place the child seat forward-facing on the vehicle
seat.
TIP: You may need to raise or remove the vehicle
head restraint to achieve best fit of the child seat.
LATCH Installation
• Figure A illustrates a forward-facing LATCH
installation.
• Verify that your vehicle is equipped with LATCH
anchors. If LATCH anchors are not available, you
must use vehicle belt installation methods.
Installation: Forward-Facing
C
A
WARNING!
• This child seat must not be used forward-facing
for children less than one year of age OR who
weigh less than 20 lbs (9.1 kg).
• This child seat must be in full upright position
when installed forward-facing for children who
weigh more than 33 pounds (15.1 kg).
b
D