Britax ROUND ABOUT 50 - Manual (Page 43)

41
Care and Maintenance
Child Seat Cover Removal
WARNING! Do not take apart the harness. Never remove
the buckle tongues from the harness. They cannot be reattached
after removal. If assembled incorrectly, the child seat may not
perform as intended.
1 Loosen the harness by lifting the harness
adjuster lever while pulling the shoulder
straps forward as far as possible.
2 Unhook the shoulder straps from the harness
yoke on rear of child seat (Fig. A).
3 Pull the upper harness straps through the
shell and cover to the front of child seat.
4 Remove the upper portion of the cover. Be
careful not to damage the energy-absorbing
foam.
5 Remove the buckle and belly pad by turning
the metal buckle strap retainer of the buckle
on the underside of the child seat so the
short side will slide through the child seat
shell (Fig. B).
6 Push the retainer through the slots in the shell
and cover to the top of the child seat.
7 Pull the lower harness straps, buckle tongues,
and chest clip through lower slots in cover.
8 Remove the entire cover from child seat.
For additional demonstration please visit www.BritaxUSA.com.
Refitting the Cover:
To refit the cover, reverse the previous directions. Make
sure the shoulder straps are properly threaded through the chest clips and the
harness is not twisted.
A
b