Bay Technical Associates DS2-RPC - Manual (Page 34)

DS-RPC OWNER’S MANUAL
DETAILED OPERATION AND CONFIGURATION
__________________________________________________________________________________________
26
CONFIGURATION
DS71 OR DS71-MD2 If you are using the Menu Selection Method,
CONFIGURATION select C, “Configure,” followed by <cr>
from the DS-RPC Main Menu. The
following selection menu appears:
Configuration
Module 1 ................................................1
Module 2 ................................................2
Module 3 ................................................3
Select Port .............................................S
Exit ........................................................X
Enter Request :
If you are using the ASCII Character String
Method, exit main menu, then select the
module to configure. To select Module #1,
type $BT1<cr>. The DS71 or DS71-MD2
responds “Requested Connection Made.”
Send the ASCII configuration command
$CONFIG. The configuration menu
appears.
Enter the number of the module to
configure, followed by <cr>. To configure
the host module 1, select #1. The following
configuration menu appears for the DS71:
Copyright(C) Bay Technical Associates 1998
DS71 Data Switch Series - Host Module
Revision F.2.01
Module 1
Status.....................…………..….......1
Serial Port Configuration...……......2
Port Device Name..............………....3
Port Select Code..............…………..4
Attention Character.........……….....5
Disconnect Timeguard.....……….....6
Connect Port ID Echo....……….......7
Login Setup....................……………8
DCD Logon/Logoff.......……….........9
Unit ID........................……………...U
Configure Another Module.....….....C
Exit...........................………………...X