Bay Technical Associates DS2-RPC - Manual (Page 70)

DS-RPC OWNER’S MANUAL
DETAILED OPERATION AND CONFIGURATION
__________________________________________________________________________________________
62
RPC OPERATION The RPC menu allows the user to monitor
and control the equipment attached to each
of the RPC four receptacles. From this
menu, you can turn on, turn off, or reboot
attached equipment, individually, or all
equipment, simultaneously.
The DS-RPC recognizes three basic
operating commands: ON n<cr>, OFF
n<cr>, and REBOOT n<cr>, where n
represents the outlet number and <cr>
represents a carriage return.
There are four red LEDs on the front of the
RPC unit. There is a corresponding red LED
for each of the RPC’s four receptacles. If
any or all of the LEDs are illuminated,
corresponding receptacle(s) are turned ON,"
and consequently, attached equipment is
receiving power. If any or all of the LEDs
are not illuminated, corresponding
receptacle(s) are turned “OFF.”
Accessing Main Menu Select the RPC from the main menu. The
following status menu appears:
DS-RPC Power Control
(c) 1997 by BayTech
Rev F0.04
Circuit Breaker : On
1) . . . OUTLET 1 : Off
2) . . . OUTLET 2 : Off
3) . . . OUTLET 3 : Off
4) . . . OUTLET 4 : Off
RPC >