Bay Technical Associates DS2-RPC - Manual (Page 72)

DS-RPC OWNER’S MANUAL
DETAILED OPERATION AND CONFIGURATION
__________________________________________________________________________________________
64
The REBOOT n command will reboot or
reset equipment attached to corresponding
receptacle(s). When the command to
REBOOT (n) is sent from the RPC >
prompt, the DS-RPC powers “Off”
corresponding outlet(s) for approximately 10
seconds, then powers them up in sequence.
This command only works on outlets which
were “On” prior to the reboot.
RPC CONFIGURATION The DS-RPC configuration menu allows the
user to:
(1) set or change a password,
(2) customize the outlet name(s) to
identify equipment attached to
the RPC,
(3) enable or disable confirmation,
(4) enable or disable status menu.
The password is disabled from the factory
by making the password a carriage return. If
a password (other than a carriage return) is
set, the DS-RPC requires password entry
before allowing the user to operate the RPC
unit. The password feature is case
sensitive.
From the DS-RPC’s configuration menu, the
user can change any outlet name to outline a
unique set-up. Default outlet names are
Outlet 1, Outlet 2, Outlet 3, Outlet 4.
From the status menu’s DS-RPC > prompt,
type CONFIG. The following menu
appears: