Black Box 16 port - Manual (Page 173)

Black Box Console Server user guide 173
set server
user level:
admin Use this command to configure the home setup of the unit.
Syntax s e t s e r v e r
[ n a m e s e r v e r - n a m e ]
[ i n t e r n e t i n e t - a d d r e s s ]
[ s u b n e t s u b n e t ]
[ b r o a d c a s t b r o a d c a s t ]
[ d o m a i n d o m a i n ]
[ i p _ h o s t u s e r - i p h o s t ]
[ a u t h e n t i c a t i o n a u t h - m e t h o d ]
[ t f t p r e t r y r e t r y - v a l u e ]
[ t f t p t i m e o u t t i m e o u t - v a l u e ]
[ s e c u r i t y s e c u r i t y - s t a t u s ]
[ d h c p d h c p - s t a t u s ]
[ s s h - p r o t o c o l s s h - p r o t o c o l - s t a t u s ]
[ g u i _ a c c e s s g u i - s t a t u s ]
[ b a n n e r b a n n e r - s t a t u s ]
[ O E M - m o d e m o d e - f l a g s ]
[ s e r v i c e s X X X X ]
[ b r e a k o n - o f f ]
[ s s h b r e a k s t r i n g s t r i n g ]
W h e r e :
server-name set or change the name of the unit. The name can be a maximum of 14 characters.
After this action, you must reboot the unit; use the command reboot.
inet-address set or change the internet address of the unit. After this action, you must reboot the
unit afterwards; use the command ‘reboot’.
subnet set or change the subnet mask of your network. For information on the subnet mask
parameter, see
General installation procedure on page 24 .
broadcast set or change your broadcast address. Once you have entered an IP address and
subnet mask, the broadcast address will default to the IP address with the host
part(s) set to 255. After this action, you must reboot the unit; use the command
reboot
.