Set up procedure – Black Box 16 port User Manual
Page 39
Black Box Console Server user guide
39
Set up procedure
To manually set up an IP address proceed as follows;
1.
Set up a terminal or PC running terminal emulation. For examples of connection
pinouts see
Appendix A Cabling information
If you connect via the Admin Port you will see a display of diagnostic and bootup
messages.
Note that if you cannot emulate VT100, you will have to use the Command Line
Interface (cli); (the cli commands are described in full in
2.
At the console, with the login prompt displayed, type admin and press <return>.
3.
At the password prompt, now displayed type superuser and press <return>. This
is the default admin user password.
The command line prompt will now be displayed:
4.
At the command prompt type screen and press <return> to enter Full Screen
mode.
The main menu is now displayed:
5.
At the main menu, select ‘server configuration’. (alternatively, use the cli
command set server)
The server form will be displayed as shown in the next picture: