Bunn W/SMART FUNNEL S/N SNG0033000 & UP - Manual (Page 22)

Page 22
SET NEW RECIPE:
If not using a Smart Funnel (with a sensor coil) and/or
a G9-2T DBC or MHG Grinder, the brewer will function
as a standard Bunn Single TF DBC Brewer:
It is possible to operate the brewer without using
a Smart Funnel and/or a G9-2T DBC or MHG Grinder.
If a standard funnel, or if a non-DBC grinder is used
the brewer will automatically select a NO NAME coffee
name when the BREW switch is pressed. This means
that no name was read from the funnel's handle.
There is one NO NAME coffee program that can
be set in the brewer. It is referred to as NO NAME.
The instructions for programming the NO NAME
settings are on the following pages. The same steps
are followed for setting the recipe as those that are
used to MODIFY A RECIPE, beginning on page 21.
Note that when the display reads NO NAME, that
is when MODIFY should be pressed in order to set the
parameters for the NO NAME coffee.
NOTE: Before beginning setup, insert a funnel into the
funnel rails, and place a ThermoFresh Server beneath
the brew funnel.
REVIEW RECIPES?
NO YES
(COFFEE NAME)
MODIFYSHOWNEXT
BREW OZ. XX.X
(-) DONE (+)
BREW OZ. XX.X
(-) DONE (+)
NO-NAME
MODIFYSHOWNEXT
EXIT TO
NEXT FUNCTION
SCREEN
P2441
PROGRAMMING THE BREWER (cont.)
35879.1 071405