Bunn W/SMART FUNNEL S/N SNG0033000 & UP - Manual (Page 25)

Page 25
P2444
PROGRAMMING THE BREWER (cont.)
% BYPASS
This function allows adjustment of the amount of
water that bypasses the grounds. The number signi-
fies the percentage of the brew volume which does
not flow over the coffee grounds.
Modifying recipes - bypass percentages:
Range: 0% to 90% for all three batch sizes
NOTE: If the brewer is already in the % BYPASS screen,
it is not necessary to follow steps 1 through 6 in this
section, but proceed directly to step 7.
1. Press and hold the upper right hidden switch until
the display reads UNITS. Release the switch, then
press and release switch until the display reads
REVIEW RECIPES.
2. Press YES to proceed. The display should now
read NO NAME, along with MODIFY, SHOW and
NEXT.
3. Press and release NEXT to advance to the desired
REVIEW RECIPES?
NO YES
3 BATCHES DONE?
NO YES
3 BATCHES DONE?
NO YES
SET PULSE BREW?
NO YES
BREW OZ. XX.X
(-) DONE (+)
% BYPASS XX.X
(-) DONE (+)
NO-NAME
MODIFYSHOWNEXT
(COFFEE NAME)
MODIFYSHOWNEXT
THAT WAS THE
LAST RECIPE
EXIT TO
NEXT FUNCTION
SCREEN
ADVANCES TO ALL OTHER
COFFEE NAMES PROGRAMMED
IN THE BREWER'S MEMORY
WHEN THE LAST COFFEE NAME
IN THE BREWER'S MEMORY IS
DISPLAYED, PRESSING NEXT
WILL EXIT AND THE DISPLAY
WILL THEN READ:
SEE MODIFYING
PULSE BREW ON
THE FOLLOWING PAGE
OR PRESS AND RELEASE
ON/OFF PAD TO EXIT THE
% BYPASS SETUP AND
RETURN TO THE MAIN SCREEN
coffee name to be modified.
4. Press and release MODIFY. The display should
read BREW OZ.
5. Press and release DONE. The display should read
3 BATCHES DONE?.
6. Press and release YES. The display should now
read % BYPASS, and a batch light will be blinking.
Press and release the batch size to be modified.
7. Using (-) and (+) set the amount of bypass water
(percentage) to be dispensed around the grounds
for that particular batch size.
8. When finished, press another batch size and repeat
step 7 for each batch to be modified.
9. When finished setting all batch sizes, press DONE.
The display should read 3 BATCHES DONE?
10. If they are not correct, press and release NO to
return to the % BYPASS setup screen.
11. If the 3 batch sizes are correct, press YES. This will
advance to SET PULSE BREW. Another alterna-
tive is to press the ON/OFF sswitch to exit the %
BYPASS setup and return to the MAIN SCREEN.
35879.1 071405