AEM 30-2860 Coil-On-Plug COP Conversion Kit - Manual (Page 11)

Page 11 10-2860 B Series COP Instructions RevB 111117
Series 1 EMS Coil Dwell
Open the coil dwell template in AEM Pro by clicking on the ignition drop down menu and
going to Ignition>advanced ignition>coil dwell setup>coil dwell. Enter the values shown
below in Table 2 into the Dwell vs Batt Volts Table. The Dwell vs RPM Table should
remain constant at a value of 100. Enter a value of 30 into the Coil Dwell Factor option.
See Figure 14 below.
Voltage
Dwell vs Batt
Volts
16 37
15 37
14 40
13 45
12 50
11 52
10 60
9 65
8 70
7 70
6 70
Figure 13. Series 2 Coil Dwell Settings
Table 2. Series 1 Dwell vs Batt Volts Table Values