AEM 30-2860 Coil-On-Plug COP Conversion Kit - Manual (Page 15)

Page 15 10-2860 B Series COP Instructions RevB 111117
Separating the circuit boards requires some patience and caution. It works well to think
of the circuit board assembly as a hardcover book, with each circuit board being a
cover. Begin to separate the circuit boards, similar to opening a book. Close the circuit
boards and open again. This may take several tries. The connector between the circuit
boards will loosen up a little each time the circuit boards are opened and closed. See
Figure 22 below.
With the circuit boards separated, locate the JPT and JPC jumpers. The JPT and JPC
jumpers each have three pins. A “jumper” is placed over two of the pins, connecting the
two pins together. The pins are numbered one, two and three. Pin one is designated
by a “1” on the circuit board. See Figures 23 and 24 below for examples of jumper
positions.
Figure 22. Separating the Circuit Boards