AEM 30-2860 Coil-On-Plug COP Conversion Kit - Manual (Page 4)

Page 4 10-2860 B Series COP Instructions RevB 111117
AEM Engine Position Module (EPM)
Apply a small amount of clean engine oil to the shaft on the EPM and install the shim,
drive gear, pin, and retaining clip. See Figure 4 below.
Apply a small amount of clean engine oil to the O-ring on the EPM and install the EPM
as shown below in Figure 5. Secure the EPM using one of the stock distributor bolts
and washers.
Figure 3. Retaining Clip, Pin, Drive Gear, and Shim (left to right)
Removed from Distributor
Figure 4. EPM with Shim, Drive Gear, Pin, and Retaining Clip Installed