AEM 30-2860 Coil-On-Plug COP Conversion Kit - Manual (Page 16)

Page 16 10-2860 B Series COP Instructions RevB 111117
Place the jumpers in the positions listed in Table 3. Only the jumpers listed below
should be moved for this installation.
Jumper EMS 30-1040/30-6040 EMS 30-1050/30-6050 EMS 30-1060/30-6060
JPC1 1-2 1-2 1-2
JPC2 1-2 1-2 1-2
JPC3 1-2 1-2 1-2
JPC4 1-2 1-2 1-2
JPC5 1-2 1-2 1-2
JPT1 1-2 1-2 1-2
JPT2 1-2 1-2 1-2
The EMS is ready to be reassembled after setting the jumpers. When reconnecting the
circuit boards, be sure all the pins are lined up correctly before fully inserting the
connector. With the pins correctly lined up, hold the EMS as shown below in Figure 25.
Table 3. EMS Jumper Position Settings
Figure 23. JPT1, 2, & 3 Jumpers Shown In 1-2
position with JPT4 jumper shown in the
2-3 position for reference
Figure 24. JPC jumpers Shown In 1-2 Position