AEM 30-2860 Coil-On-Plug COP Conversion Kit - Manual (Page 7)

Page 7 10-2860 B Series COP Instructions RevB 111117
EPM Harness
Connect the 4-pin connector on the EPM harness to the mating connector on the EPM.
Make sure the connector is fully seated and locked into position. Route the harness
through the engine bay, away from any high heat sources and sharp objects, towards
the ECU. See Figure 9 below.
Wiring
EPM Harness
RED – EPM Power, Connect to 12 volts
BLACK – EPM Ground, connect to ground
GREEN – Crank Signal, connect to crank input on EMS/ECU
WHITE – Cam Signal, connect to cam input in EMS/ECU
DRAIN WIRE – Connect to power ground/drain in EMS/ECU
Figure 9. EPM Harness Connected to EPM