AEM 30-2860 Coil-On-Plug COP Conversion Kit - Manual (Page 8)

Page 8 10-2860 B Series COP Instructions RevB 111117
B Series COP Harness
RED (IGN) – Connect to switched, fused (15 A or greater) 12 volts
BLACK (GND) – Connect to ground
ORANGE (COIL 1) – Connect to Coil 1 Trigger in EMS/ECU
BLUE (COIL 2) – Connect to Coil 2 Trigger in EMS/ECU
PINK (COIL 3) – Connect to Coil 3 Trigger in EMS/ECU
GREY (COIL 4) – Connect to Coil 4 Trigger in EMS/ECU
EMS/ECU CONFIGURATION
Timing Patten
The EPM has a 24 and 1 timing pattern. There are 24 crank signals and one cam
signal for every engine cycle. Both output signals are 12 volt square waves. See
Figure 10 below.
EMS Wizard
The AEM EMS must be configured to accept the timing pattern from the EPM. In
AEMTuner, go to Wizards > Setup Wizard and select the AEM EPM. See Figure 11
below.
Figure 10. EPM Timing Pattern