AEM 30-3812 Infinity Plug & Play Harnesses - Ford Coyote to Ford Racing Controls Pack - Manual (Page 12)

12
© 2014 AEM Performance Electronics
P/N 30-3812
Manifold Pressure page for setup
and calibration. Monitor the MAP
[kPa] channel.
C1-37 Analog_In_9 AUX - 1 Fuel Pressure
12 bit A/D, 100K pullup to
5V
0-5V analog signal. Use +5V Out pins
as power supply and Sensor Ground
pins as the low reference. Do not
connect signals referenced to +12V
as this can permanently damage the
ECU. See the Setup Wizard Fuel
Pressure page for setup and
calibration. Monitor the
FuelPressure [psig] channel.
C1-38 Analog_In_10 --- Baro Sensor
12 bit A/D, 100K pullup to
5V
0-5V analog signal. Use +5V Out pins
as power supply and Sensor Ground
pins as the low reference. Do not
connect signals referenced to +12V
as this can permanently damage the
ECU. See the Setup Wizard
Barometric Pressure page for setup
and calibration. Monitor the
BaroPress [kPa] channel.
C1-39 Analog_In_11 --- Shift Switch Input
12 bit A/D, 100K pullup to
5V
0-5V analog signal. Use +5V Out pins
as power supply and Sensor Ground
pins as the low reference. Do not
connect signals referenced to +12V
as this can permanently damage the
ECU.
See the 1D lookup table
'ShiftSwitch' for setup. Also
assignable to multiple functions.
See Setup Wizard for details.
C1-40 Analog_In_12 --- Mode Switch
12 bit A/D, 100K pullup to
5V
0-5V analog signal. Use +5V Out pins
as power supply and Sensor Ground
pins as the low reference. Do not
connect signals referenced to +12V
as this can permanently damage the
ECU.
See the 1D lookup table
'ModeSwitch' for input state.
A multi-position rotary switch such
as AEM P/N 30-2056 is
recommended.
Also assignable to
multiple functions. See Setup Wizard
for details.
C1-41 +5V_Out_1
Engine
E - 9
'Electronic Throttle
Control (ETCREF)
Regulated, fused +5V
supply for sensor power
Analog sensor power
C1-42 +5V_Out_1 AUX - 4 +5V Out
Regulated, fused +5V
supply for sensor power
Analog sensor power
C1-43
HighsideSwitch_
1
AUX - 9 HS1 (switched 12V)
0.7A max, High Side Solid
State Relay
See Setup Wizard page 'HighSide
Assigment Tables' for configuration
options. See 2D lookup table
'HS1_Table' for activation settings.
C1-44
HighsideSwitch_
0
--- VTEC
0.7A max, High Side Solid
State Relay
See Setup Wizard page 'HighSide
Assigment Tables' for configuration
options. See 2D lookup table
'HS0_Table' for activation settings.
See Setup Wizard page 'Honda VTEC'
for default activation criteria.