AEM 30-3812 Infinity Plug & Play Harnesses - Ford Coyote to Ford Racing Controls Pack - Manual (Page 7)

Ford Coyote 5.0L V8 7
© 2014 AEM Performance Electronics
When a ground is provided this drops Analog20’s voltage from 5 volts to 0 volts, this transition in voltage
sets the ClutchSwitch channel to 0 (5 volts) or 1 (0 volts).
Drive By Wire
The base calibration will set most of the Drive-By-Wire (DBW) channels for the stock 5.0L Coyote throttle
body. If a different throttle body is used, Supra Cobra or Cobra Jet, then further adjustments to the DBW
channels may be required. To complete the DBW setup the Drive By Wire Wizard must be ran.
Select Calibrate sensor data only and follow the DBW Setup steps.
Note: There are a few integrated DBW fail safes incorporated into the Infinity system. For instance, if the
accelerator pedal and throttle position sensors do not track each other, or if the maximum DBW current
is exceeded, there will be a fatal error which will kill the engine for safety purposes. This error will reset
when the ignition key is turned off momentarily, and then turned back on.
Variable Valve Control (VVC)
The AEM Infinity system supports Fords Coyote’s Variable Valve Control. The base calibration is
configured with base VVC settings that may need adjustment.
For proper VVC function, the user must sync the cam timing by following the instructions listed in Setup
Wizard: Wizards>Setup Wizard>VVC>VVC Cam Sync. Once the cam sync has been verified for all four
cams, variable valve control may be enabled by checking the boxes next to each camshaft in the VVC