AEM 30-3812 Infinity Plug & Play Harnesses - Ford Coyote to Ford Racing Controls Pack - Manual (Page 8)

8
© 2014 AEM Performance Electronics
P/N 30-3812
Enable section of the Wizard.
Ford Racing Control Pack Harness Fuel Pump Modification
(Optional):
To allow the Infinity to control the fuel pump a modification must be made to the C47 flying lead
connector. The Green w/ Black stripe wire is the Highside Fuel Pump relay control wire (C47-01). The
Ford Racing harness double crimps 12v Start & Run (C47-03 ISP-R) to this fuel pump highside so that
the fuel pump is running when the key is on.
The Green w/ Black stripe wire needs to be cut off of this double crimp.
Reinstall the Green w/ Black stripe wire’s pre-existing pin back into the C47-01 socket. Route a wire that
connects the Green w/ Black stripe wire to the adapter harness connector labeled “Fuel Pump”. Extra
crimp terminals are provided to adapt this wire to the Deutsch DTM connector on the adapter harness.