AEM 30-3812 Infinity Plug & Play Harnesses - Ford Coyote to Ford Racing Controls Pack User Manual
Page 25
Ford Coyote 5.0L V8
25
© 2014 AEM Performance Electronics
Ford Racing
PCM50
Infinity Assignment
Pin
Destination
Ford Coyote with FR
Control Pack
Infinity Hardware
Specification
Notes
Description
1
---
---
---
---
---
2
---
---
---
---
---
3
---
---
---
---
---
4
UEGO 1 UN
C1-7
UEGO 1 UN
Bosch UEGO controller
Nernst Voltage signal. Connect to
pin 1 of Bosch UEGO sensor
5
---
---
---
---
---
6
---
---
---
---
---
7
---
---
---
---
---
8
---
---
---
---
---
9
---
---
---
---
---
10
---
---
---
---
---
11
---
---
---
---
---
12
---
---
---
---
---
13
---
---
---
---
---
14
---
---
---
---
---
15
UEGO 1 VM
C1-8
UEGO 1 VM
Bosch UEGO controller
Virtual Ground signal. Connect to
pin 5 of Bosch UEGO sensor.
16
UEGO 2 IP
C2-47
UEGO 2 IP
Bosch UEGO controller Pumping Current signal. Connect to
pin 6 of Bosch UEGO sensor
17
UEGO 1 IP
C1-6
UEGO 1 IP
Bosch UEGO controller Pumping Current signal. Connect to
pin 6 of Bosch UEGO sensor
18
---
---
---
---
---
19
Analog_In_20
C2-33
Clutch Position
(Neutral Switch)
Blunt Lead
12 bit A/D, 100K pullup
to 5V
0-5V analog signal. Use +5V Out pins
as power supply and Sensor Ground
pins as the low reference. Do not
connect signals referenced to +12V
as this can permanently damage
the ECU. 'See ClutchSwitch 1-axis
table for setup options. Input can
be assigned to different pins. See
Setup Wizard page 'Input Function
Assignments' for input mapping
options.
20
---
---
---
---
---
21
---
---
---
---
---
22
---
---
---
---
---
23
---
---
---
---
---
24
UEGO 1 Heat
C1-4
UEGO 1 Heat
Bosch UEGO controller
Lowside switch for UEGO heater
control. Connect to pin 4 of Bosch
UEGO sensor. NOTE that pin 3 of the
Sensor is heater (+) and must be
power by a fused/switched 12V
supply.
25
---
---
---
---
---
26
---
---
---
---
---
27
---
---
---
---
---
28
UEGO 2 IA
C2-48
UEGO 2 IA
Bosch UEGO controller Trim Current signal. Connect to pin
2 of Bosch UEGO sensor