Fast dual-sync distributor – AEM Infinity Supported Applications - Universal V8 Engine User Manual
Page 20
20
© 2014 AEM Performance Electronics
FAST Dual-Sync Distributor
The FAST Dual-Sync distributor outputs both an 8 tooth per cycle Hall Effect crank position signal and a
single Hall Effect cam position signal. The cam and crank sensor pickups inside the distributor are fixed
thus no adjustment is necessary. **NOTE** During testing, this distributor exhibited degraded ignition
timing accuracy. AEM recommends thoroughly testing any "dual sync" style distributor to ensure that it
offers acceptable ignition timing control.
1. Install distributor. (See
, in this document.) Final installed distributor should have
rotor aligned with terminal #1 with engine at TDC for cylinder #1.
2. Wiring:
FAST Dual Sync Distributor
Wire
Desc
Connect To
Wire
Desc
Connect To
Red
+12V sensor power
Main relay power out
White
Crank signal
C1-21 Crk Pos Sens Hall
Black
Sensor ground
C1-20 Sensor Ground
Blk/Wht
Cam signal C1-22 Cam Pos Sens Hall
Note: Use shielded w iring w ith drain to ground.
3. Load FAST base session and review Setup Wizard. (See
, in this document.)
4. Sync ignition timing. (See
, in this document.)