AEM Infinity Supported Applications - Universal V8 Engine - Manual (Page 24)

24
© 2014 AEM Performance Electronics
Step 8
Remove the lower section of the advance
mechanism that has the 8 tooth reluctor
wheel on it by sliding it down and off the
shaft.
Step 9
Carefully remove the appropriate teeth
leaving only the single tooth identified in
step 3. An air grinder with cut off wheel
followed by a sanding disc works well for
this operation.
Step 10
Re-assemble the advance mechanism by sliding the lower section back onto the shaft. Be sure to locate
the advance stop bushing pin into the small hole in the lower section to lock the advance mechanism.
Install the washer and lock nut onto the advance stop bushing pin.