Lull 1044C-54 Series II Operation Manual - Manual (Page 99)

Section 5 - Attachments
5-31 31200608
Installation Procedure:
• Ensure carriage is properly installed. Refer to “Attachment Installation” on
page 5-9.
• Secure the fork mounted hook to the forks by sliding the fork mounted hook onto
the parent forks and install the retaining pin behind the vertical shank of the fork.
Operation:
• Pallet or lumber forks of an appropriate load rating must be used. Do not use with
cubing or block forks.
• Weight of rigging must be included as part of total load being lifted.
• Do not use with mast carriage attachment.
• Do not use fork mounted hook with attachments capable of rotating (i.e. side tilt
and swing carriages) without disabling the rotation feature(s).