Smittybilt 761336 Tonneau Cover - Manual

WWW.SMITTYBILT.COM
Smittybilt, 400 West Artesia Blvd, Compton, CA 90220
Installation Instructions
Tonneau Cover
(Part # 761335, 761336)
07-11 Jeep Unlimited (4-Door)
Step 1:
Depending on what your vehicle is equipped with; remove your hardtop and or soft top including
entire bow assembly. It is also recommended to remove the softop pivot brackets that are installed
on the sport bar using a # 30 Torx. (Keep the tailgate bar to the side, it will be reused later)
Step 2:
Lay the tonneau over the rear of the vehicle. (Fig A)
Step 3:
Open roll bar flaps and wrap the tonneau around the sports bar. Do not fasten flaps together yet.
(Fig B)
(Fig A) (Fig B)
Step 4:
Install the OEM tailgate bar onto the tonneau by sliding the “C” channel on the bar over the sewn
in channel (tube) on the tonneau. (Fig C) Once that is done, insert the bar into the mounting
brackets on each side of the tailgate opening.
Step 6:
Secure the sides of the tonneau by sliding the sewn in plastic strip on the cover into the
channel on the vehicle. (Fig D)
Step 7:
Secure the corners also by sliding the plastic strips on the cover into the channels on the vehicle.
(Fig E)
Step 8:
Now secure the roll bar flap covers by fastening the Velcro strips together. (Fig F)
Note: Read instructions entirely before attempting to install this product.
Open roll bar flaps and wrap the
tonneau around the sports bar