Blade ICE G8000 - Manual (Page 126)

RackSwitch G8000 Application Guide
126 „ Chapter 8: Basic IP Routing BMD00041, November 2008
5. Assign a VLAN to each IP interface.
Now that the ports are separated into VLANs, the VLANs are assigned to the appropriate IP
interface for each subnet. From
Table 8-3 on page 125 , the settings are made as follows:
6. Configure the default gateway to the routers’ addresses.
The default gateway allows the switch to send outbound traffic to the router:
7. Enable IP routing.
8. Verify the configuration.
Examine the resulting information. If any settings are incorrect, make the appropriate changes.
RS G8000 (config)# interface ip 1 (Select IP interface 1)
RS G8000 (config-ip-if)# ip address 205.21.17.3
RS G8000 (config-ip-if)# ipvlan 1 (Add VLAN 1)
RS G8000 (config-ip-if)# enable
RS G8000 (config-vlan)# exit
RS G8000 (config)# interface ip 2 (Select IP interface 2)
RS G8000 (config-ip-if)# ip address 100.20.10.1
RS G8000 (config-ip-if)# ipvlan 2 (Add VLAN 2)
RS G8000 (config-ip-if)# enable
RS G8000 (config-ip-if)# exit
RS G8000 (config)# interface ip 3 (Select IP interface 3)
RS G8000 (config-ip-if)# ip address 131.15.15.1
RS G8000 (config-ip-if)# ipvlan 3 (Add VLAN 3)
RS G8000 (config-ip-if)# enable
RS G8000 (config-ip-if)# exit
RS G8000 (config)# interface ip 4 (Select IP interface 4)
RS G8000 (config-ip-if)# ip address 206.30.15.1
RS G8000 (config-ip-if)# ipvlan 4 (Add VLAN 4)
RS G8000 (config-ip-if)# enable
RS G8000 (config-ip-if)# exit
RS G8000 (config)# ip gateway address 205.21.17.1
RS G8000 (config)# ip gateway enable
RS G8000 (config)# ip routing
RS G8000 (config)# show vlan
RS G8000 (config)# show interface information
RS G8000 (config)# show interface ip