Blade ICE G8000 - Manual (Page 141)

RackSwitch G8000 Application Guide
Appendix A: Troubleshooting „ 141 BMD00041, November 2008
Port Mirroring behavior
This section describes the composition of monitored packets in the switch, based on the
configuration of the ports.
The following port-mirroring cases apply to the G8000:
„
Ingress mirrored packets are not modified.
„ Egress mirrored packets are tagged with the PVID of the egress port.
Configuring Port Mirroring
To configure port mirroring for the example shown in Figure A-1 :
1. Specify the monitoring port, the mirroring port(s), and the port-mirror direction.
2. Enable port mirroring.
3. View the current configuration.
RS G8000 (config)# port-mirroring monitor-port 3 mirroring-port 2 in
RS G8000 (config)# port-mirroring monitor-port 3
mirroring-port 12 out
RS G8000 (config)# port-mirroring enable
RS G8000# show port-mirroring
Port mirroring is enabled
Monitoring Ports Mirrored Ports
1 none
2 none
3 (3, in) (12, out)
4 none
5 none
...