Blade ICE G8000 - Manual (Page 68)

RackSwitch G8000 Application Guide
68 „ Chapter 4: Ports and Trunking BMD00041, November 2008
2. Repeat the process on the other switch.
3. Connect the switch ports that will be members in the trunk group.
Trunk group 3 (on the G8000) is now connected to trunk group 1 (on the other switch).
N OTE – In this example, two G8000 switches are used. If a third-party device supporting link
aggregation is used (such as Cisco routers and switches with EtherChannel technology or Sun's
Quad Fast Ethernet Adapter), trunk groups on the third-party device should be configured
manually. Connection problems could arise when using automatic trunk group negotiation on
the third-party device.
4. Examine the trunking information on each switch.
Information about each port in each configured trunk group is displayed. Make sure that trunk
groups consist of the expected ports and that each port is in the expected state.
The following restrictions apply:
„
Any physical switch port can belong to only one trunk group.
„ Up to eight ports can belong to the same trunk group.
„ All ports in static trunks must be have the same link configuration (speed, duplex, flow
control).
„ Trunking from third-party devices must comply with Cisco ® EtherChannel ® technology.
RS G8000 (config)# portchannel 1 member 1,7,32
RS G8000 (config)# portchannel 1 enable
# show portchannel
# show portchannel information
PortChannel 3: Enabled
port state:
2: STG 1 forwarding
23: STG 1 forwarding
30: STG 1 forwarding