AirLive WN-300USB - Manual (Page 22)

15 WN-300USB v3 User’s Manual
Scan result includes 6 types of information, they are:
A The SSID (Service Set Identifier) of wireless device. If nothing is displayed here, it means
the SSID of this wireless device is hidden.
If a symbol appears in front of the name of wireless device, means you’ve established
connected with that wireless device.
B The type of this wireless device and the channel number of this wireless device.
Means this wireless device is an access point
Means this wireless device is a computer (Ad-Hoc mode, point-to-point connection)
C The wireless standard supported by this access point is displayed here.
‘n’ for 802.11n , ‘g; for 802.11g , and ‘b’ for 802.11b .
WPS icon will appear when the access point supports WPS. If the access point uses
encryption, a key icon will appear.
Note: When the access point supports WPS and WPS icon is appeared, you will not see the
key icon here even through the access point uses encryption.
D Shows the signal strength of access point by percentage.
E Shows the bar graph of the signal strength.
If you can not see the access point you wish to connect here, please click ‘Rescan’ button to scan
for access point again, until the one you preferred is displayed. You may have to click ‘Rescan’
for more than two times before you can see the access point you wish to use here.
If you still can not see the access point you wish to use after clicking ‘Rescan’ for more than five
times, please move your computer closer to the location where the wireless access point is, or
see instructions in Chapter 3-2 ‘Troubleshooting’.
A B C D E