AirLive WN-300USB - Manual (Page 33)

WN-300USB v3 User’s Manual 26
When you use 'EAP-FAST' as authentication type, the protocol setting is
always 'Generic Token Card' and can not be changed. You also need to select
‘Soft Token’ or ‘Static Password’ as password in ‘ID \ Password’ setting.
’EAP Fast’ authentication type also have a sub-menu to set EAP fast-specific
parameters:
If you need to use protected authentication credential, check ‘Use protected
authentication credential’ box, and click ‘Import’ to load .pac credential file; to
remove a loaded credential file, click ‘Remove’.
Session
Resumption
You can enable or disable session resumption here. If you don’t know if you
should enable session resumption or not, please ask your 802.1x
authentication administrator.
ID \ Password tab Input 802.1x username (ID) and password and other information if it is required
here. Click ‘Show Password’ to show the password you typed.
Client Certification
tab
Use this tab to select a local certificate from dropdown menu. If the access
point you wish to connect required a specific client certificate, the certificate
must be installed on your computer, and you can select the certificate here.
Server
Certification tab
Use this tab to use server-based certification. Please select a CA (Certificate
Authority) from dropdown menu. If intermediate certificates are allowed, please
select ‘Allow intermediate certificates’. Also, if you need to specify CA server’s
name, you can specify it in ‘Server name’ field. You can select ‘Server name
must match’, so the CA server’s name must be the same with the value you set
in ‘Server name’ field; If only the domain name part of full server name must the
same with the value you set in ‘Server name’ field, select ‘Domain name must
end in specified name’.