AirLive WN-300USB User Manual
Page 51
WN-300USB v3 User’s Manual 44
All access points with WPS function enabled will be displayed here. Please make sure the
access point you wish to connect is displayed. If not, please click ‘Rescan’ few more times. You
can also click ‘Information’ button to see the detailed information about selected access point.
5. Start PBC pairing procedure at access point side (please refer to the instruction given by your
access point’s manufacturer), then click ‘PBC’ button in wireless configuration utility to start to
establish wireless connection by WPS. Please be patient (This may require several seconds to
one minute to complete). When you see ‘WPS status is connected successfully’ message,
means the connection between this wireless network card and access point is successfully
established by WPS, and the information about access point you connected to will be displayed.
6. You can click ‘Detail’ button to see detailed information of connected access point. If you wish to
save this connection as a profile, you can click ‘Export Profile’ button, and this connection will be
saved. You can find this connection in ‘Profile’ tab in a later time.
7. Sometime WPS may fail (In the following picture, WPS pairing is failed because no
WPS-enabled access point is found):