CCTV Camera Pros iDVR-PRO A Series DVRs - Manual (Page 60)

System Setting
60 |
System Setting
\ \ System Event
You can set any action to an event related to the disk, recording, network or system. Like the other events, you may
notify the event to the user using the alarm/buzzer output, OSD pop-up or email.
1. From <SYSTEM SETUP> - <EVENT>, select <SYSTEM EVENT>.
2. Use the [ ▲▼◀▶ ] buttons on the remote control or use the mouse to specify the reaction to each event.
3. To apply the change, click <APPLY> in the bottom of the screen.
4. When done, press the [EXIT] button on the remote control or click <CLOSE> in the lower screen. The confirmation
message appears and you will return to the previous menu.
Disk
i
OVERWRITE START EVENT : if you set the disk
write mode to <OVERWRITE>, this event occurs
when the disk is full and the overwriting begins
accordingly.
i
DISK FULL EVENT : if you set the disk write mode
to <ONCE>, this event occurs when the disk is full
(100%).
i
DISK SPACE EXHAUSTED EVENT : Event that is
triggered if the disk is almost full.
Click to specify the threshold percentage of
usage to trigger the event.
i
S.M.A.R.T EVENT : Occurs if the disk causes the
S.M.A.R.T error.
i
NO DISK EVENT : Occurs if no disk is recognized after the booting due to a disk failure or cable problem.
J To detect the disk error, it is recommended not to change the settings of the S.M.A.R.T event, no disk event and buzzer output.
Record
i
PANIC RECORD START EVENT : Specify the
action to perform when the panic recording begins.