Comelit RAS_SOLUTION - Manual (Page 32)

25
Figure 24 Event Setup - SMTP
4.3.1 SMTP setting
① Select the SMTP tab.
② Check/Uncheck the Enable SMTP.
③ The Sender is the email address of the system administrator.
④ The Interval is the mailing interval. The range is from 1 min to 24 hours.
⑤ The Aggregate Events is the count of the events to send.
* If the Interval is 1 minute, this would check event to send every minute. If the Interval is 24 hours, this
would check event to send in a day and send it.
* If the Aggregate Events value is 50, this would not send email until 50 events happened.
* If the Interval is 1 hour and the Aggregate Events value is 50, this would check and send email in every
hour. And if the number of events is over 50, this would send an email every hour.
4.3.2 SMTP server information
① Check/Uncheck the Use Mail Server.
② Fill the mail server address and port to the list.
③ Fill the Login Name and Password of the mail server address.
④ Select the Login Method.
* Without SMTP server information, there MAY be a failure in the email transmission.
4.3.3 Receiver and SMTP Test
The maximum mailing list is 10. If you want to test mailing, enter the receiver address and click the Test
button.