Dakota Ultrasonics MX-5 DL - Manual (Page 29)

MX-5 DL Ultrasonic Thickness Gauge
25
Note:
•
The display will flash FILE / F-01 (or the last file used) symbol.
Remember, there are 10 files F-01 thru F-10.
3) Press the SEND key to enter file setup.
Using the Data Logger (con't)
•
The current file will be diplayed ( F-01, F-03, etc. )
4) Press the UP / DOWN arrow keys to scroll to the file ( 1-10 ) that
will be used to record the measurements.
5) Press the SEND key once again to select the file.
Note:
•
The display will flash the FILE / F-04 ( The selected file )symbol.
6) Press the MEM key, once again, to advance to the storage
locations in the file selected.
Note:
•
The display will flash the current storage location ( L007, L039, etc.
), followed by the status of the location. The storage location can
contain one of three possible things: a) a measurement that was
previously stored. b) A clear location, indicated by the CLr
symbol. c) Obstruct ( ObSt ), indicating that a measurement could
not be obtained.
7) Press the UP / DOWN arrow keys to advance to the desired cell
location.
8) Take a measurement and press the SEND key to store a reading in
the desired location.