Elkhart Brass Stinger RF8297 - Manual (Page 11)

8
E. RF Transmitters
The 8297 RF monitor uses W.E.T. (Wireless Electronic Technology), an innovative
wireless radio link, to send all commands from the RF Transmitters to the RF
Receiver/Control Module. This new wireless link gives the operator the ability to
view the discharge stream and target from virtually any point of view from up to ¼
mile from the monitor.
81282001 Handheld RF Transmitter (Figure 8)
A sealed handheld radio remote contains all the controls
necessary for operation of the monitor. The handheld
remote allows the operator to direct the monitor from a
significantly improved point of view. With the wireless
remote, the operator can view the stream from the side and
confirm that the stream is hitting its target. Separate push
button switches are provided for up, down, left, right, fog,
and stream functions. The handheld rem0otes have user
selectable security codes that allow multiple transmitters
and monitors to operate on the same fireground at the
same time. The remote has an automatic power down
feature that will shut down the power after 5 minutes of no
activity. As an additional power saving feature the radio
signal is only transmitted while a button is pushed. The
handheld remote case has a NEMA 4 rating.
Figure 8
81282001 Handheld Transmitter
81327111 Panel Mount Primary Transmitter
(Figure 9) The fixed transmitter sends signals to the
monitor via an encoded radio signal, requiring no wires
between the transmitter and the monitor. It is powered by
the 12V vehicle electrical system. The faceplate is
intended for a flush mount onto the pump control panel.
Separate sealed push button switches are provided for up,
down, left, right, fog, and stream functions. It will override
any handheld control, allowing the apparatus operator to
retain ultimate control over the monitor. Comes with 10
foot coax antenna cable and (1) 90° antenna and (1) straight
antenna.
Figure 9
81327111 Panel Mount Primary
Transmitter
81353101 OEM Primary Transmitter
(Figure 10) The OEM Transmitter allows the OEM to use
their own switching arrangement while still providing the
benefits of W.E.T. It has all of the same features of the
Primary Panel Mount Transmitter, but has a wiring harness
for the installer to connect to OEM supplied switches.
Comes with 10 foot coax antenna cable and (1) 90°
antenna and (1) straight antenna.
Figure 10
81353101 OEM Primary Transmitter