Elkhart Brass Stinger RF8297 - Manual (Page 17)

14
81353101 Fixed OEM Supplied Switches
a) Place a 1A fuse between the red lead of the
transmitter and a switched positive power lead on
the vehicle. Attach the black lead from the
monitor base to the vehicle ground.
b) Connect all of the switch commons to the Ground
(Black) connection.
c) Connect each function to a corresponding switch.
To operate the function close the function switch
to ground. Any combination of pushbuttons or
toggle switches can be used.
d) Power indication can be created by attaching an
LED and proper resistance between the VCC (+3
V) and Ground connections. Max rating for the
VCC connection is 250 mA.
e) The transmitters antenna is to be mounted using
the 10 foot antenna cable provided to locate one
of the antennas outside the vehicle compartment
in a position that provides the least obstructed
line of sight to the monitor’s antenna.
Function Wire Color
Ground Black
VCC (+3 V)
(Output only)
Red
Right Brown
Down Orange
Up Yellow
Left Green
Stream Blue
Fog Violet
Aux2 Gray
Oscillate White
Aux1 White/Black
Stow White/Brown
Table 2
C. Communications Address Setup
A RF transmitter controls the 8297 RF monitor. The transmitter is digitally encoded with
a security code to ensure that it does not accidentally control the wrong monitor. The
receiver has a matching decoder and security code that instantaneously decodes and
interprets commands. The security code is a 15-bit selectable code that is set on both the
remote transmitter and the receiver.
The 8297 RF monitor is tested and shipped with a security code based upon the monitor
serial number, ensuring each monitor leaves the factory with a unique code assigned to it.
The security settings will normally not need to be changed. In the case of a lost
transmitter or replaced control board, contact Elkhart Brass.
Danger:
Using two W.E.T. monitors with the same security code will cause
the inadvertent control of the wrong monitor, resulting in possible property damage and
injury to personnel. Using the factory specified codes will prevent this problem.
Caution:
While reassembling the handheld remote, ensure that battery and antenna leads do not
become pinched. Ensure all O-rings and gaskets are properly installed when closing
receiver or controller enclosures.