Elkhart Brass Stinger RF8297 - Manual (Page 19)

16
Note: Do not set the security switches to either all “ON” or all “OFF.” These
are invalid settings and will not allow the transmitter to function. In the handheld
transmitter, this will be signaled by the power and low battery signals flashing slowly at
the same time.
Caution:
Do not change the switch A position 1 on any transmitter. This
switch is used to set the priority setting of the transmitter and changing this switch may
remove override capabilities.
81282001 Handheld Transmitter Settings
Remove the battery cover from the handheld transmitter. Remove the four screws
holding the two halves of the cover together using a #1 size Pozidriv

screwdriver (use
caution with a standard Phillips screwdriver as it may eventually strip the heads of the
screws).
Locate the security code switches on the transmitter circuit board (see Figure 15).
Change the switches to the settings from Table 3 (pg 15). One incorrect setting will
prevent the system from working.
Ensure the battery lead connector is securely fastened to the transmitter circuit board.
Close the cover halves and replace the screws. Do not exceed 6 in-lbs of torque. The
screws should just be snug, do not over tighten the screws, or the plastic enclosure could
strip.
Caution:
While reassembling the handheld remote, ensure that battery and
antenna leads do not become pinched.
Figure 15
Transmitter Security Settings