Monitor settings, Monitor selector, Red programming button – Elkhart Brass Stinger RF8297 User Manual
Page 18
15
Monitor Settings
Table 3
Record Security Settings
Switch
1
2
3
4
5
6
7
8
A
B
A
B
Monitor Location
Monitor Security Code
Remove the cover from the control module mounted on the monitor.
D
S5
D
S2
B
A
D
S1
SW
4
SW
1
D
S4
P2
D
S3
P3
D
S6
P1
P4
SW
2
SW
3
Status LED
Red Programming
Button
Figure 14
24263001 Receiver Layout
Locate the security code switches on the control module circuit board (see Figure 14).
Change the code using the switches A and B. Switch A position 1 is not used for security
code settings.
For convenient reference to the security code of the monitor; enter the code into Table 1
provided above.
Monitor Selector
SW4 (Figure 14) allows this board to be used in different product applications. In
order for it to properly operate the Stinger RF monitor, it must be set to 5. If it is
set to a value that is not yet programmed, the status indicator LED, DS5 (Figure
14), will blink rapidly until a valid setting is selected and power is cycled off and
back on. If SW4 is set to a valid setting but not position 5, unpredictable results
will occur.