Elkhart Brass Stinger RF8297 - Manual (Page 20)

17
81327111 and 81353101 Panel Mount and OEM Transmitters
Disconnect the power connector to the panel-mounted transmitter at the back of the
panel.
Open the back cover of the transmitter after loosening the screws.
Remove the red and black power leads from the power conversion board and place the
cover to the side.
Locate the security code switches on the transmitter circuit board (see Figure 15).
Change the switches to the settings from Table 3 (pg 15). One incorrect setting will
prevent the system from working.
Reconnect the power leads. The Red lead is attached to the Positive (+) terminal; the
black lead is attached to the Negative (-) terminal.
Close the transmitter cover and replace the screws.
Reconnect the power connector.
Keep this Installation Manual in a secure place so the settings can be retrieved if
needed.