Elkhart Brass Stinger RF8297 - Manual (Page 25)

22
Warning:
When up-down manual override is used, it is possible to position the nozzle elevation
below the electronic safety limit of 30

above horizontal. Use extreme caution to
prevent sliding of monitor when using manual override control.
Left-Right
The left-right manual override is controlled by a pushbutton located on top of the
left-right drive gearcase on the right side of the monitor. See Figure 20. To
override the motor drive mechanism, push and hold this button down while using
the other hand to rotate the monitor upper portion and nozzle to the desired
position.
Figure 20
Left-Right Manual Override
Caution:
With the drive mechanism disengaged, there is no monitor left-right
rotation lock. It may be possible for the stream position to drift due to vibration.
Maintain close watch over stream position.
When motor is again actuated, the transmitter left-right drive will automatically re-
engage. This may take a few seconds of motor travel.
F. Power Switch
The power switch is used to control power to the monitor. If shore power is not available
and the power switch is in the OFF position, this will remove power form all circuits
inside the monitor. There will be no display indicators of any kind. If the switch is in the
ON position, the monitor will operate in the portable mode as described in section VI
paragraph B.
If shore power is present, the monitor will operate as describe in section VI paragraph C
in either the ON or the OFF position.