Elkhart Brass Stinger RF8297 - Manual (Page 15)

12
Figure 12a Figure 12b
Partial Ring Gear
B. 8298P RF Deck Mount Adapter
Attach the 8298P RF to the 3” NPT male thread on the water supply pipe. Seal the joint
with a suitable pipe thread sealant. Tighten the 8298P RF with a 24-inch strap wrench.
Damage to any surfaces may interfere with installation of the upper monitor assembly.
The 8298P RF deck mount comes with either a full or partial ring gear. The full ring gear
allows the Stinger RF to move 360 degrees. The partial ring gear will allow the Stinger
RF to move 270 degrees. The 8298P RF with the partial gear ring will need to be
positioned correctly before mounting (See Figure 12).
Warning:
The piping must be able to withstand a horizontal reaction force
of at least 900 lbs at the height of the discharge elbow and from any angle of rotation that
the monitor is capable of turning. Serious injury to personnel and damage to equipment
can result from improper installation.
Power Cable Wiring
Place a 10A fuse between the red lead of part number 36846000 power cable and
unswitched positive power lead on the vehicle. Attach the black lead from the power
cable to the vehicle ground. The power source should be the output from an on-board
battery charger/conditioner so that the Stinger RF battery will be maintained at full
charge level while apparatus is standing in the station.
All control functions are sent to the monitor via an encoded RF signal from the
transmitter; no control wiring is needed.
Flange Base with Gear Orientation Shown