ElmoMC Gold Line Digital Servo Drives-Gold Solo Whistle - Manual (Page 12)

Gold Solo Whistle Installation Guide
MAN-G-SOLWHIIG-EC (Ver. 1.500)
||Unpacking the Drive Components| www.elmomc.com
12
Table of Contents
Chapter 5: Installation
The Gold Solo Whistle must be installed in a suitable environment and properly connected to its
voltage supplies and the motor.
5.1. Unpacking the Drive Components
Before you begin working with the Gold Solo Whistle, verify that you have all of its components, as
follows:
• The Gold Solo Whistle servo drive
• The Elmo Application Studio software and software manual
The Gold Solo Whistle is shipped in a cardboard box with Styrofoam protection.
To unpack the Gold Solo Whistle:
1. Carefully remove the servo drive from the box and the Styrofoam.
2. Check the drive to ensure that there is no visible damage to the instrument. If any damage
has occurred, report it immediately to the carrier that delivered your drive.
3. To ensure that the Gold Solo Whistle you have unpacked is the appropriate type for your
requirements, locate the part number sticker on the side of the Gold Solo Whistle. It looks
like this:
4. Verify that the Gold Solo Whistle type is the one that you ordered, and ensure that the
voltage meets your specific requirements.
The part number at the top provides the type designation. Refer to the appropriate part
number in the section Catalog Number at the beginning of the installation guide.
The part number of the Gold Solo Whistle (EtherCAT version) has an E, for example, G-
SOLWHI10/100E whereas the CAN version has an S, for example G- SOLWHI10/100S.
There are two models of the Gold Solo Whistle: connectors only (for currents of 10 A or less) and
wires only (for currents of 15 A or more). On request, the wires model may be ordered for currents
of 10 A or less.